Skripsi
STUDI POLA ALIRAN AIR-UDARA PADA KEMIRINGAN PIPA 60° KE ATAS TERHADAP POSISI HORIZONTAL
Air–water two-phase flow is a flow phenomenon involving liquid and gas phases flowing simultaneously within a pipe. The characteristics of two-phase flow are influenced by several parameters, such as superficial velocity, pipe orientation, and interfacial interactions that lead to the formation of specific flow patterns. In upward inclined pipes, gravitational effects make the distribution of gas and liquid phases more complex compared to horizontal pipes, making the analysis of flow patterns and void fraction important. Research on two-phase flow in pipes inclined 60° upward is still relatively limited, particularly using plexiglass pipes that enable direct visual observation of the flow patterns formed. This study objected to identify the characteristics of air–water two-phase flow patterns, construct a flow pattern map based on variations in superficial liquid and gas velocities, and analyze the relationship between superficial velocity to void fraction and liquid holdup in a pipe inclined 60° upward from the horizontal position. The experiment was conducted using a 1-inch diameter plexiglass pipe with an test section length of 1 meter. Water and air were used as the working fluids with co-current flow direction. The water flow rate variations ranged from 5–13 Gpm, while the air flow rate variations ranged from 10–50 Lpm. Flow visualization data were recorded using a camera in the observation section and analyzed to determine the flow patterns, superficial gas velocity (J_g ), superficial liquid velocity (J_l ), void fraction, and liquid hold-up. The results showed that the observed flow patterns under the operating conditions of this study were bubble flow, plug flow, and slug flow. At low superficial gas velocity conditions (Jl =1,3691-1,6180 m/s, Jg = 0,3288-0,8220 m/s), the flow was dominated by bubble flow because the liquid phase still dominated the flow regime. As the superficial gas velocity increased, bubbles merged through a coalescence process, developing into plug flow (Jl =0,6223-1,6180 m/s, Jg = 0,3288-1,1508 m/s), and subsequently into slug flow (Jl =0,6223-1,6180 m/s, Jg = 0,6576-1,6440 m/s). An increase in superficial gas velocity also caused the void fraction to increase, while an increase in superficial liquid velocity tended to increase the liquid hold-up. The resulting flow pattern map indicated a transition trend from bubble flow to plug flow and subsequently to slug flow as the superficial gas velocity increased. The results showed tendencies consistent with previous studies, although slight shifts in the flow pattern transition boundaries were observed due to differences in pipe diameter, operating conditions, and the range of superficial velocities used in this study.
No other version available