Skripsi
ANALISIS PROTOTIPE THERMOELECTRIC GENERATOR (TEG) MENGGUNAKAN PEMANFAATAN PANAS ASPAL DENGAN PERBANDINGAN SISTEM PENDINGIN PASIF WATER COOLANT (ETHYLENE GLYCOL + AIR) DAN WATER COOLANT (PROPYLENE GLYCOL + AIR)
The utilization of solar renewable energy is carried out by using asphalt as a heat-absorbing medium and a thermoelectric generator (TEG) to convert temperature differences between the hot and cold sides into electrical energy. This study designs a prototype based on six SP1848-27145 SA TEG modules connected in series. The hot side uses asphalt with an additional 2 mm copper plate applied consistently across all prototypes. The cooling side varies: the first prototype uses only a heatsink, while the second and third prototypes use a heatsink with a water-cooling system employing two different fluids, namely ethylene glycol + water and propylene glycol + water. The highest average values of temperature difference (ΔT), voltage, current, and output power for the heatsink-only prototype are 1.9°C, 0.259 V, 0.000178 A, and 0.000045851 W, respectively. For the prototype using ethylene glycol + water cooling, the values are 6.7°C, 0.355 V, 0.000197 A, and 0.000069288 W. Meanwhile, the prototype with propylene glycol + water cooling produces 2.9°C, 0.275 V, 0.000191 A, and 0.000052363 W. These results indicate that the addition of a water-cooling system, particularly using ethylene glycol + water, improves temperature stability. This fluid performs better than propylene glycol + water due to its lower viscosity, which allows more effective heat transfer and reduces heat retention within the fluid. As a result, a greater temperature difference is achieved, leading to higher voltage, current, and overall power output.