Skripsi
UJI KINERJA DAN DAYA TAHAN MEMBRANE ELECTRODE ASSEMBLY (MEA) PADA PERALATAN PEMFC MULTISEL UNTUK EMERGENCY LAMP
This study aims to analyze the performance and durability of the Membrane Electrode Assembly (MEA) in a multi-cell Proton Exchange Membrane Fuel Cell (PEMFC) system applied as an energy source for an emergency lamp. The MEA, as a key component, plays an important role in determining system performance; therefore, comprehensive characterization and testing were conducted. The MEA used in this study was a used MEA that had been pre-treated and tested in a multi-cell PEMFC system consisting of 10 cells with an active area of 195 cm² for each cell. Characterization was carried out using Cyclic Voltammetry (CV), Electrochemical Impedance Spectroscopy (EIS), and Linear Sweep Voltammetry (LSV) to evaluate electrochemical properties, electrochemical surface area, electrical conductivity, and charge capacity. The results showed an Electrochemical Surface Area (ECSA) of 1.036 × 10⁻⁷ m²/g, an electrical conductivity of 5.84 × 10⁻¹⁰ S/cm, and a charge value obtained from LSV of 1.04 × 10⁻⁷ C. Performance testing was conducted using polarization curves (I–V) and power curves (I–P) with variations in oxygen supply using a blower and without a blower at a hydrogen flow rate of 200 mL/min. The MEA with a blower produced an optimum power density of 92.05 mW/cm² and a current density of 14.87 mA/cm², while without a blower it produced a power density of 75.01 mW/cm² and a current density of 13.33 mA/cm². Durability testing was conducted for 12 hours at the laboratory scale and through an on–off cycling method for 5 cycles to simulate the operational conditions of an emergency lamp.
No other version available